Yanmar 1820D front driveline and sheild

[Callan]

Need help I bought tractor without front driveline and can’t find a replacement any help appreciated anyone make their own

 

[RustyA]

FRONT DRIVESHAFT - NEW - HOYE EXCLUSIVE!

Check out the deal on FRONT DRIVESHAFT - NEW - HOYE EXCLUSIVE! at Yanmar Tractor Parts

www.hoyetractor.com

 

[RustyA]

I assume by driveline you meant driveshaft?

 

[RustyA]

The shield and hardware are listed separate in the parts view illustration but I think hoye can fix you up with what you need.

 

[Callan]

Tried Hoye they referred me to this forum

 

[Callan]

Hoye responded

 

[RustyA]

Hmm were you requesting a used driveshaft? Perhaps I was mistaken but I looked your shaft up on their website. Maybe the shield is no longer available? What happened to the original driveshaft?

 

[Callan]

Bought tractor from a guy who bought it from a guy and only used 2wd

 

[alexpops]

Hoye shows a driveshaft with ujoint end but no splined end for around 200. You could measure the distance from transfer case to differential & if the length is shorter, buy the hoye shaft, take it to a machine shop with the tractor & have them cut and spline/yoke it for you depending on the connection needed. You'll still need shield & ujoint/ fasteners/seals, but the drive shaft should be done. Would need to make sure the xfer case isn't trash ... why would someone pull the shaft from a working xfer case even if they don't use 4wd?

I blew a rearend in eastern Wyoming/western Nebraska once on a datsun 4x4, pulled the shaft and limped into Cheyenne on front wheel only, but kept the original driveshaft to mate up to a boneyard rear end.

 

[alexpops]

If that doesn't work, a driveline shop should be able to custom fab one for you. Might not be oem, but it would work.