Yanmar 1510D Seat Post

ChuckT · Dec 3, 2005

I'm replacing the "pan" seat on my wife's 1510D. The new seat (from Hoye) will fit better after I finish a little work on the seat post. A picture is attached.

Can anyone tell me what was attached to the base where the arrow is pointing? I have removed the two 6 mm x 1.00 hex screws that were there and replaced them with ss machine screws.

There were fiber washers (one each) under the screw heads as if the screws were there to attach something that needed insulation.

TIA
CVT

jimstractors · Dec 8, 2005

A red plastic tool box usually mounts there.

ChuckT · Dec 9, 2005

The tool box? On the diagram in the Yanmar parts book it looks like the box is behind the seat.

cvt

HoyeTractor · Dec 9, 2005

Jim is correct. It is for the tool box. You can see a little bit of it in this picture, and a little bit in this one. Its too cold (20 is cold for us here in TX) to go take a good picture right now so I tried to find some old shots that might show it.

Aaron
Parts@HoyeTractor.com
(940)438-0386

ChuckT · Dec 11, 2005

Ok - I took a closer look at the parts diagram. It seems to show the tool box fitting in that space. What holds the box in? Some sort of a strap or clamp? Or does the box just sit there?

cvt