Woods RM59 Shaft

[Saskstallion]

Hi All.
I'm looking at getting a 3 point finishing mower for my Kubota B7100.
I found a great deal on a good Woods RM59, and I saw that the front shaft needs to be a certain length for a Kubota tractor (or any other smaller tractor).
The seller of the mower said that it was used on an International 674.
Without measuring the shaft of the mower (it's currently under a bunch of snow apparently) is there any way to tell if it would be compatible with my tractor?
If it turns out the shaft isn't compatible, am I able to get it cut to fit?

 

[90cummins]

It’s most likely too long but can be shortened.
New tubes are available, had to replace mine it twisted off due to insufficient engagement.
90cummins

 

[gstrom99]

I had one of those for my 9N. It is a great mower, but beware that the belt is a bit hard to find and expensive. I had to shorten the shaft on mine. It's easy, with the right tools. Pretty hard with a hack saw.

GS

Hi All.

If it turns out the shaft isn't compatible, am I able to get it cut to fit?