Woods RM59 Shaft

   / Woods RM59 Shaft #1  

Saskstallion

New member
Joined
Mar 7, 2018
Messages
10
Location
Sherwood Park, AB
Tractor
Kubota B7100D
Hi All.
I'm looking at getting a 3 point finishing mower for my Kubota B7100.
I found a great deal on a good Woods RM59, and I saw that the front shaft needs to be a certain length for a Kubota tractor (or any other smaller tractor).
The seller of the mower said that it was used on an International 674.
Without measuring the shaft of the mower (it's currently under a bunch of snow apparently) is there any way to tell if it would be compatible with my tractor?
If it turns out the shaft isn't compatible, am I able to get it cut to fit?
 
   / Woods RM59 Shaft #2  
It’s most likely too long but can be shortened.
New tubes are available, had to replace mine it twisted off due to insufficient engagement.
90cummins
 
   / Woods RM59 Shaft #3  
I had one of those for my 9N. It is a great mower, but beware that the belt is a bit hard to find and expensive. I had to shorten the shaft on mine. It's easy, with the right tools. Pretty hard with a hack saw.

GS


Hi All.

If it turns out the shaft isn't compatible, am I able to get it cut to fit?
 
 

Tractor & Equipment Auctions

CENTRAL PNEUMATIC  GAS 135 PSI (A52472)
CENTRAL PNEUMATIC...
City of Buckhannon - 1990 International 2574 Truck (A52384)
City of Buckhannon...
WOODS DHS48N LOT NUMBER 75 (A53084)
WOODS DHS48N LOT...
Wolverine BC-13-72W, 72" Skid Steer Brush Cutter (A52384)
Wolverine...
2005 Blue Bird BB Conventional Bus, VIN # 1BAKBCKA45F219634 (A51572)
2005 Blue Bird BB...
ATLAS XAS110 COMPRESSOR (A52472)
ATLAS XAS110...
 
Top