Wheel spacers

[Ole Orange]

Not really sure where to post this question but?? I have a 40 HP Kubota 3650 and the rear wheels/rims have 2 sets of mounting holes. It appears as though if I use the inner mounting holes it will space out my rear wheels about 4 to 5 inches more over all than they are now. Will this make much difference on traction, stability, etc. What would be the benefits? 4 inches does not seem like it would make much of a change?

As always thanks for any help

 

[blin]

Hi Ole. I had similar questions. Check out my recent thread in the Kubota owning and operating section. It's called "Rear Wheel Spacing". Hope it helps.

 

[Ole Orange]

Thanks I took a look at it today

Hi Ole. I had similar questions. Check out my recent thread in the Kubota owning and operating section. It's called "Rear Wheel Spacing". Hope it helps.

 

[TripleR]

No, it doesn't seem like much, but it makes a significant difference, we have our L5740 set as wide as they will go. Last year, we added aftermarket spacers to our BX2200 and 2600 and the difference was really noticeable.

 

[George2615]

If you need wider spacing give these guys a call for spacers.

https://www.motorsport-tech.com/special/tractor/kubota_s