What would these 2 parts be called?

[landor]

I just discovered this after doing some heavy bush hogging with my 2610 - this is the left stabilizer arm, and both that U-shaped joint was bent and the pin was snapped off. Any idea what these parts are called so I can order them? I looked at Michigan Iron's website under the hitch section, but I don't see these parts there, and can't seem to find a diagram anywhere else that tells me what to buy. Any idea what these would be called? (I'm willing to buy the whole stabilizer arm assembly if necessary, I just need some guidance on where to buy.) Thank you!

 

[K5lwq]

The clevis is held on with a pin. Take that off and go to Tractor Supply and get a new pin that fits the hole. Then just re-attach. I do not see any other issue.

 

[K5lwq]

Just in case you are confused it should pin to the arm I circled in red.

 

[landor]

Is the clevis being bent an issue? It's not a huge bend, but it definitely doesn't look like the right arm clevis.

 

[ptsg]

In addition to what K5lwq said, take the pin of the other side for reference if you're not sure on the diameter and length of it.

 

[K5lwq]

Is the clevis being bent an issue? It's not a huge bend, but it definitely doesn't look like the right arm clevis.

Nope. It swivels. I can not tell from the pictures that it is bent.

 

[landor]

Here's a better picture of the left one:

https://imgur.com/0JPwL7L

And the right one for reference:

https://imgur.com/E4Wfl7v

I'm seeing a small bend on the left side of it, I'm guessing from doing some backing up when I was mowing.

 

[landor]

The thing that really bugs me is that I can't find the lower telescoping stabilizer's in the MIE parts directory anywhere.

 

[K5lwq]

I still do not see it as a problem as long as the pin will go through. If it will not you should be able to straighten that one once you remove it.

 

[DK35vince]

Like was said earlier. The pin fell out is all you need.