John D
Silver Member
Im going to build a welding trailor to pull around the place and need some ideas on extra stuff I may need on it. any do's and dont's would help. jb
Welding trailor
- Thread starter John D
- Start date
- Views: 2010
MadReferee
Elite Member, Rest in Peace
- Joined
- Apr 28, 2003
- Messages
- 3,862
- Location
- New Hampshire
- Tractor
- Kubota B2710, IH TD6-62 dozer with Drott 4n1 bucket loader
Try asking in one of the welding projects forums. I know others over there have built welding trailers. A little searching will give you all the information you want.
Hobart Welding Projects
Miller Welding Projects
Also if you look in the Miller Idea Gallery (accessable from the Miller Projects forum) way at the bottom, you will find a picture that one member took of his homemade welding trailer. There are several threads in the Miller Projects forum on welding trailers.
Hobart Welding Projects
Miller Welding Projects
Also if you look in the Miller Idea Gallery (accessable from the Miller Projects forum) way at the bottom, you will find a picture that one member took of his homemade welding trailer. There are several threads in the Miller Projects forum on welding trailers.
OP
John D
Silver Member
Thanks. jb
JRP
Platinum Member
I started to design a trailer. Here are a few ideas:
My plans had a roll off table That rolled over the welder when not in use. This provided an additional cover to keep rain off. The welder controls could be accessed with the table on the trailer.
The trailer also had a long slim table over eash side covering the fenders. One side was set up to hold a chop saw and with rollers at the same heigth as the saw vise. It also had a small air compressor and an air tank mounted at the hitch tongue.
The welder I wanted was a Miller Bobcat so it would have plenty of power.
Check out Miller's website project area.
My plans had a roll off table That rolled over the welder when not in use. This provided an additional cover to keep rain off. The welder controls could be accessed with the table on the trailer.
The trailer also had a long slim table over eash side covering the fenders. One side was set up to hold a chop saw and with rollers at the same heigth as the saw vise. It also had a small air compressor and an air tank mounted at the hitch tongue.
The welder I wanted was a Miller Bobcat so it would have plenty of power.
Check out Miller's website project area.
