Welding Table: My first big project

[lynrob]

Yeah, it's solid as a rock! I started out by working in one axis picking the table up with my pallet jack, adjusting the levelers and letting it down again until I got it level. It only took a few iterations until I got it pretty good. Then I worked on the other axis using the same method. As I recall there was a little interaction between the axes, but I had it leveled up in no time. It is very solid. I have mounted my vice via one of the receiver tubes and I can really reef on it and nothing moves at all.

I designed it with 4 levelers because I thought I might want to fine tune the height but so far the height has been just about right so I haven't fiddled with it.

 

[Deano]

Super nice table! And, you did not have to ask...you KNOW you did a great job! I don't think the cost was too far out at all.:thumbsup:

Deano