Want a 3PH sprayer...

   / Want a 3PH sprayer... #21  
What "oil" do you use in the pump and what "books" are you refering too?

Gary
 
   / Want a 3PH sprayer... #22  
What "oil" do you use in the pump and what "books" are you refering too?

Gary
 
   / Want a 3PH sprayer... #23  
If this application is going to be a one time job, you should be able to find a lawn care co. that will do the application for you, for less than the cost of the new sprayer?
 
   / Want a 3PH sprayer... #24  
If this application is going to be a one time job, you should be able to find a lawn care co. that will do the application for you, for less than the cost of the new sprayer?
 
   / Want a 3PH sprayer... #25  
LeadPoison,
If you have a soil conservation office in your area, they will rent you a sprayer for next to nothing a day.
 
   / Want a 3PH sprayer... #26  
LeadPoison,
If you have a soil conservation office in your area, they will rent you a sprayer for next to nothing a day.
 
   / Want a 3PH sprayer... #27  
Ditto on all that farmwithjunk said. Follow his post exactly. Tee-jet is the tip to get. I like the XL in a size 02 - yellow. A small boom with XL tips will give much much better results than a boomless nozzle.

A 55 gallon sprayer would be good for an M4900. You will have to fill it once in the middle of your job.

Get two 3/4" NPTM 90 x 3/4 F banjo and two hose to 3/4 M banjo fittings for your pump connections. This will let you unhode your pump in seconds. Otherwise, removing the pump to clean and oil it (30w motor oil is fine) is much more difficult. Clip or tie wrap the banjo fitting levers so the don't open and dump your sprayer contents. This last advice comes from experience.
 
   / Want a 3PH sprayer... #28  
Ditto on all that farmwithjunk said. Follow his post exactly. Tee-jet is the tip to get. I like the XL in a size 02 - yellow. A small boom with XL tips will give much much better results than a boomless nozzle.

A 55 gallon sprayer would be good for an M4900. You will have to fill it once in the middle of your job.

Get two 3/4" NPTM 90 x 3/4 F banjo and two hose to 3/4 M banjo fittings for your pump connections. This will let you unhode your pump in seconds. Otherwise, removing the pump to clean and oil it (30w motor oil is fine) is much more difficult. Clip or tie wrap the banjo fitting levers so the don't open and dump your sprayer contents. This last advice comes from experience.
 
   / Want a 3PH sprayer... #29  
Do you have any Southern States stores?
 
   / Want a 3PH sprayer... #30  
Do you have any Southern States stores?
 
 

Tractor & Equipment Auctions

2018 WACKER NEUSON CORPORATION DBA WACKER NEUSON LTV6 LIGHT TOWER (A52472)
2018 WACKER NEUSON...
2012 Ford E-150 Passenger Van (A51692)
2012 Ford E-150...
2018 Lexus IS300 Sedan (A51694)
2018 Lexus IS300...
NEW Wolverine Skid Steer Drive and Augers (A53002)
NEW Wolverine Skid...
Ford Super Duty Pickup Truck Bed (A51691)
Ford Super Duty...
2013 TOYOTA TUNDRA (A52472)
2013 TOYOTA TUNDRA...
 
Top