Urethane cutting edge

[studor]

The other place to check is a belting supply house -- they would have a variety of materials that would work as a wear edge

 

[Low Bucket]

Either 3/4", 7/8", or 1". I do not remember. I have since gotten rid of the piece of equipment it was on. I though about trying to get a 1/4" or 3/8" piece when I rebuilt my snowplow last fall for the face but ended up just going back to steel.

Chris

Thanks!

Any size over 1/2" will work.

 

[GPintheMitten]

Not the product you asked about, but a farmer I knew used a tire to scrape the feedlot. I think it was a large tractor tire but you could improvise with most any tire large enough I think. He cut it to open it and cut some of the sidewalls down, spread it out into an arc and attached it to a 3 point hitch. It had a lot of capacity and also worked like a squeegie.

 

[Mundy]

I work at the county and some of the plows here have a wing plow on the side to clear shoulders. It has a cutting edge that looks like pieces of tire stacked next to each other. Seems to work well kind of like the belt supply idea.

 

[sal64]

hello i get mine from curbel plastics 1 inch buy 8 inch uhmw they cut to your lenth i think i paid 150. lasts me 2-3 yrs.