tu2100F questions

ekodish · Jun 11, 2004

I recently bought an iseki tu2100f

So far it is working great. I have a couple questions I was hoping you have answeres.

1) What are the PTO speeds (there are three)

2) What size is the PTO

3) How much horsepower does it have. I have seen anything from 17-25hp listed on different sites.

4) I am looking to pull a manure spreader with it. What is the largest size you think i could pull?

thanks

jimstractors · Jun 11, 2004

1. 1st=540 2nd=usually around 1200, 3rd is 1 to 1 with engine rpm, I think. You use 1st (540) for post hole diggers, tillers, mowers, etc. Use the other ranges for PTO hydraulic pumps, etc.
2. My Iseki TA210 has the standard 1-3/8, 6 spline, and so should yours.
3. The first 2 digits (21) is the PTO HP. Multiply that times 1.2 to get engine HP (25).
4. I have a customer pulling a Millcreek model 8700 (72 cu ft) with a 21HP Yanmar.

ekodish · Jun 11, 2004

great response,
thank you

corelokt308win · Jun 11, 2004

Howdy,
My TL2100F pulls an 8 ft pto spreader like it wasn't there. It also brush hogs better than the Case 430 it replaced. I run a 4ft. brush-hog, but it would run a 5ft. easily. I only use the lowest speed on the pto.