Hello - I am looking for a tooth bar for my 49" bucket on my 200CX FEL. There are two people on eBay selling them: Yankeewarehouse ($190+shipping) and United Steel Works ($230+shipping). Both companies said they need to custom make the bar because the JD 49" bucket is not standard. Does anyone know where to get an off-the-shelf tooth bar for the JD 49" bucket?
Tooth bar needed for 49" bucket 200CX FEL
- Thread starter bheston
- Start date
- Views: 11744
JDFANATIC
Veteran Member
Femco can take care of you.
Mackinac Joe
Member
Try Markham Welding. I ordered a toothbar from them Tuesday and it arrived Saturday.
A 53" toothbar with seven teeth (2 more than standard) shipped from Tennessee to Michigan cost me just under $300.
Markham Welding - Tooth Bar
Joe
A 53" toothbar with seven teeth (2 more than standard) shipped from Tennessee to Michigan cost me just under $300.
Markham Welding - Tooth Bar
Joe
EdC
Gold Member
Markham does make a really good unit. I have an ATI which is way, way overbuilt for a 200CX, really like it but much more than I need with a 2320.
Joe, have you tried yours out yet?
Joe, have you tried yours out yet?
JDFANATIC
Veteran Member
Oops, my bad, I was in such a hurry and have been considering the FEMCO foldable ROP. I really meant Markham, they were great to work with for my toothbar.JDFANATIC said:
Mackinac Joe
Member
Ed, I have not mounted my toothbar yet. That'll be the 4th of July project, I guess. I hate to drill holes in that nice, new, green paint, but it must be done!
Joe
Joe
Chris2520
Platinum Member
I just wonder how much a Markham tooth bar weighs for a 61 inch bucket. I got the JD toothbar for my 2520. and its brutal. its indistrutable. but it weighs about 150 pounds. the machine handles it fine. it me thats the problem. I am a big guy. and while your working , you dont run over to the shop and through it on. its a beast to handle.... its really made for a 3000 seris. I think i read somewhere that the Markham toothbar was about 60 pounds. this would make it so much easier to put on and remove. i might concider this. does anyone know how much one would weigh for a 61 inch JD bucket...
Chris......
the machine handles it fine. it me thats the problem. I am a big guy. and while your working , you dont run over to the shop and through it on. its a beast to handle.... its really made for a 3000 seris. I think i read somewhere that the Markham toothbar was about 60 pounds. this would make it so much easier to put on and remove. i might concider this. does anyone know how much one would weigh for a 61 inch JD bucket... Chris......
ducati996
Banned
Chris2520 said:I just wonder how much a Markham tooth bar weighs for a 61 inch bucket. I got the JD toothbar for my 2520. and its brutal. its indistrutable. but it weighs about 150 pounds.
Chris......
I probably have a markham for the standard 61" bucket - its heavy but I think its about 100 lbs or less. It wont break and is very well made, and the teeth are replaceable