Tool tray behind ROPS

[keony]

I made a new tray to hold a larger tool box, and added QCs with top and tilt.

 

[Tinhack]

Very nice! Although it sure looks busy back there. :confused2:

 

[keony]

Very nice! Although it sure looks busy back there. :confused2:

Yes, it is busy! Project revised 3 or 4 times as I learned, next time (if there is a next time) I will get custom length hoses made, off the shelf I ended up a little bit too long. The 3 pt. and top link are raised all the way in photo making it even busier!

 

[Tinhack]

I'm in the process of repainting my Ford. While I have it down, I'm adding three remotes. Two will be used for Top-N-Tilt and one for implements. I've got all my hoses ready (covered) and a bag full of ties. I'm hoping it won't look like bowl of spaghetti.

I've got the locks on the T-n-T cylinders so if I need another remote for an implement, I could pull the tilt lines and use those. (I think)

Don't worry about looks. Function is best. It will come together, I'm sure. :thumbsup:

 

[keony]

I'm in the process of repainting my Ford. While I have it down, I'm adding three remotes. Two will be used for Top-N-Tilt and one for implements. I've got all my hoses ready (covered) and a bag full of ties. I'm hoping it won't look like bowl of spaghetti.

I've got the locks on the T-n-T cylinders so if I need another remote for an implement, I could pull the tilt lines and use those. (I think)

Don't worry about looks. Function is best. It will come together, I'm sure. :thumbsup:

Sounds like a good project.
I think it looks good enough and it functions well with no excess bends or pinches. Have to mount the rear facing light in a new spot, but that's easy.