keony
Silver Member
I made a new tray to hold a larger tool box, and added QCs with top and tilt.
Tool tray behind ROPS
- Thread starter keony
- Start date
- Views: 2784
OP
keony
Silver Member
Yes, it is busy! Project revised 3 or 4 times as I learned, next time (if there is a next time) I will get custom length hoses made, off the shelf I ended up a little bit too long. The 3 pt. and top link are raised all the way in photo making it even busier!
Tinhack
Elite Member
- Joined
- Jul 3, 2020
- Messages
- 3,470
- Location
- Lytle, TX
- Tractor
- Ford 3910, John Deere 420C, Kubota G32XKS, IH 2606, Bad Boy Maverick-60"
I'm in the process of repainting my Ford. While I have it down, I'm adding three remotes. Two will be used for Top-N-Tilt and one for implements. I've got all my hoses ready (covered) and a bag full of ties. I'm hoping it won't look like bowl of spaghetti. 
I've got the locks on the T-n-T cylinders so if I need another remote for an implement, I could pull the tilt lines and use those. (I think)
Don't worry about looks. Function is best. It will come together, I'm sure. :thumbsup:
I've got the locks on the T-n-T cylinders so if I need another remote for an implement, I could pull the tilt lines and use those. (I think)
Don't worry about looks. Function is best. It will come together, I'm sure. :thumbsup:
OP
keony
Silver Member
I'm in the process of repainting my Ford. While I have it down, I'm adding three remotes. Two will be used for Top-N-Tilt and one for implements. I've got all my hoses ready (covered) and a bag full of ties. I'm hoping it won't look like bowl of spaghetti.
I've got the locks on the T-n-T cylinders so if I need another remote for an implement, I could pull the tilt lines and use those. (I think)
Don't worry about looks. Function is best. It will come together, I'm sure. :thumbsup:
Sounds like a good project.
I think it looks good enough and it functions well with no excess bends or pinches. Have to mount the rear facing light in a new spot, but that's easy.
