Tipping trailer use

[docfoc]

I am new owner of a Kubota B7001D 4x4 ( with front loader and rear 3 point hitch) and have bought a tipping trailer for muck. The trailer and tractor both have a quick fit hydraulic connector, however I am not sure how to divert the hydraulic power from 3 point hitch or loader to the trailer.
I have been told to raise the 3 point hitch to max height at which point the hydraulic fluid will be directed to the trailer ram... is this correct as so far it has not worked... am I missing something...
thanks

This is the current set up..

 

[aczlan]

Can you push in on the middle piece of both quick connects?
What happens if you remove the quick connect and drop the end of the hose in a bucket (do this with the 3 point all the way down)?
I would suspect that there is a problem with one of the quick connects.

Aaron Z

 

[docfoc]

I had wondered if it was the connectors... If I drop it into a bucket with the three point down presumably the fluid will pour out . or will this only happen if it is all the way up... ?

 

[aczlan]

I had wondered if it was the connectors... If I drop it into a bucket with the three point down presumably the fluid will pour out . or will this only happen if it is all the way up... ?

It shouldn't dump out any fluid until you move the lever to lift the 3 point.

Aaron Z

 

[docfoc]

Thanks Aaron... will give it a go in the morning (10pm here in UK),,cheers

 

[J_J]

Need more info.

Where did you plug in the hose for the hyd fluid?

What valve is controlling the fluid to the tipping trailer.

Is the cyl a SA or DA cyl?

 

[ishiboo]

Looks like it's in the relief of the 3-point.

 

[J_J]

I am not sure you can obtain the relief fluid as it goes directly to tank.

 

[aczlan]

Need more info.
Where did you plug in the hose for the hyd fluid?
What valve is controlling the fluid to the tipping trailer.
Is the cyl a SA or DA cyl?

That model is setup so that you can tie a SA cylinder in parallel with the 3 point ram, then when you raise the 3 point, it can push fluid into the external ram at the same time.
See: http://www.orangetractortalks.com/forums/showthread.php?t=501 for some discussion on the subject (sadly without working pictures)

Aaron Z

 

[docfoc]

That model is setup so that you can tie a SA cylinder in parallel with the 3 point ram, then when you raise the 3 point, it can push fluid into the external ram at the same time.
See: Extra hydraulics on B7001? - OrangeTractorTalks - Everything Kubota for some discussion on the subject (sadly without working pictures)

Aaron Z

Problem sorted , I temporarily disconnected the feed back lever from the control arm which meant I could have the control arm on maximum resulting in the fluid being diverted to the tipping trailer... thanks for the advice

 

[aczlan]

Problem sorted , I temporarily disconnected the feed back lever from the control arm which meant I could have the control arm on maximum resulting in the fluid being diverted to the tipping trailer... thanks for the advice

Glad to hear that its working.

Aaron Z