robertdawber
New member
- Joined
- Jul 29, 2018
- Messages
- 5
- Tractor
- Ford 3000 Satoh 650g
Can anyone help with timing of a 650 g? There are two marks on the pulley. I would be grateful
Timing
- Thread starter robertdawber
- Start date
- Views: 1521
PILOON
Super Star Member
I'd suspect one mark would be TDC (top dead center) to adjust valves with the other being BTDC (before TDC) to adjust the points.
(I am assuming the 'G' is a gas engine.)
(I am assuming the 'G' is a gas engine.)
CausticUrbanCoast
Platinum Member
- Joined
- Nov 7, 2018
- Messages
- 554
- Tractor
- Mitsubishi
An image of the markings would be helpful, one might just be a casting flaw or rating.
Mine, from after Mitsubishi took over Satoh, is the inside mark on the pulley. I attached the capture from the service manual for mine - if it's the same the second mark, it is the IT mark. I am guessing IT is the start of the intake stroke.
You can also pull a valve cover (guessing yours is diesel) and manually turn the crank until the first rocker is highest and then verify your marks (only if you have already drained the oil).
Mine, from after Mitsubishi took over Satoh, is the inside mark on the pulley. I attached the capture from the service manual for mine - if it's the same the second mark, it is the IT mark. I am guessing IT is the start of the intake stroke.
You can also pull a valve cover (guessing yours is diesel) and manually turn the crank until the first rocker is highest and then verify your marks (only if you have already drained the oil).
Here are some similar links:
