Tilt stopped working.

[duckhunter27]

Thought i would share this with everyone. I was pileling ceder trees and it was very thick and alot of brush anyhow i went to dump trees in to pile and my forks would not tilt but about 2 inches. I got ceders off and backed up and checked tractor over my loader would go up and down no problem but my tilt would only go about 2 in either way. what i found was that one of the quick couplers under the tractor to the loader had came undone was hard to see but one coupler was about a 1/4 inch farther out then the rest. Released all pressure and poped it back in worked fine.

 

[wallace]

This is a very common issue in the compact tractor/loader industry.
Even if it doesn't look like the are disconnected. We always tell our customers to disconnect and reconnect just to make sure.:thumbsup:

 

[duckhunter27]

I felt lucky to find the problem so fast and just wanted to pass alone to anyone else working it thick bruch etc.

 

[Army grunt]

I had the verry same thing after washing my N H. I use a soft brissol brush on a pole. seems Ihit one quick connect an had same problem. I think I asked here an got back on track tks. to quick reply from a fellow.
Army Grunt