cj7
Gold Member
Everything I have. Except not everything was available 25 yrs ago!
The one thing that you wonder why you didn't buy sooner?
- Thread starter marhar
- Start date
- Views: 120868
John0829
Veteran Member
I had forgotten about using LPG for cutting, first time I saw it was when my then future FIL was cutting something in his shop (a couple of hundred years ago
). Even though it does not give as hot a flame as acetylene being a small time dirt farmer and local mechanic for neighboring farmers he used it because it was less expensive.
ArlyA
Super Star Member
- Joined
- Mar 18, 2016
- Messages
- 12,188
- Tractor
- Outlander1000 6x6, Ego lawn mower and shopping for tractor
LPG cutting tips seem to get dirty asap and are harder to clean out.
CADplans
Elite Member
I used propane as the fuel on my CNC torch for over a decade of production cutting.
The propane produced a much nicer cut edge than acetylene.
I had almost zero tip cleaning issues, but, all of my cuts had been programmed to keep the tip clean,
After preheat, the torch moved slightly, so that when the oxygen was started, the blast coming out of the cut would be directed up at an angle, rather than directly back at the tip.
Some weeks, I would go through an entire 100 pound bottle of propane, just cutting parts.
The propane produced a much nicer cut edge than acetylene.
I had almost zero tip cleaning issues, but, all of my cuts had been programmed to keep the tip clean,
After preheat, the torch moved slightly, so that when the oxygen was started, the blast coming out of the cut would be directed up at an angle, rather than directly back at the tip.
Some weeks, I would go through an entire 100 pound bottle of propane, just cutting parts.
ArlyA
Super Star Member
- Joined
- Mar 18, 2016
- Messages
- 12,188
- Tractor
- Outlander1000 6x6, Ego lawn mower and shopping for tractor
Who all here has a CNC torch?
Too many Kubotas
Veteran Member
Sorry. Just basic plasma cutters.
ArlyA
Super Star Member
- Joined
- Mar 18, 2016
- Messages
- 12,188
- Tractor
- Outlander1000 6x6, Ego lawn mower and shopping for tractor
That what I'm looking at. 220 ones.
Too many Kubotas
Veteran Member
Yep, 220s. Not that I need high capacity cutting all that often, but it's hard to fake it when working on thicker stuff.
CADplans
Elite Member
I have two 220 volt cutters,,
this one,,
and a Hypertherm 45XP,,
The ESAB is over 20 years old, I sorta retired it and use the 45XP,,
Both cut nice,,
this one,,
and a Hypertherm 45XP,,
The ESAB is over 20 years old, I sorta retired it and use the 45XP,,
Both cut nice,,