GillieBrook
New member
- Joined
- Sep 6, 2011
- Messages
- 4
- Tractor
- JD 5105
Looking for a tech manual for John Deere 521 loader.
CTM103519 is the manual part number
CTM103519 is the manual part number
May I ask what's so complicated on a FEL that one needs a TM??
Is item 11 what you bought, need to replace?
yes, #11 is what i bought and based on sight, i thought the pin went through both arms.
closer inspection today, it's obvious there are separate pins on each end that hold the arms in place.
i just wasn't sure what the proper technique to use in replacing the bent section.
logically it would appear that i must cut the pipe and then drive out the short pin on 1 side and slide the #11 pin through the arm and re-insert the old shorter pin.
for some reason this shorter pin setup is not shown in the diagram, or any other diagram i found of the same part display.
The drawing shows 11 as the only part, but separate pins would be more logical. If you have separate pins you should have four retaining pins (number 5). One for each end pin and two for number 11. Does yours have four retaining pins?
I would NOT cut the center bar. I would remove both end pins, then the bent bar. I would have the bent bar straightened.