OP
PowerTracManiac
Silver Member
No luck so far.
Taking a break from it as it is not a high priority.
Taking a break from it as it is not a high priority.
Stump Cutter Teeth
- Thread starter PowerTracManiac
- Start date
- Views: 6866
two_bit_score
Super Star Member
- Joined
- Dec 22, 2008
- Messages
- 12,580
- Tractor
- John Deere 110 TLB, Diamond C 19LPX GN trailer
A lot of these threads are like the proverbial “tar baby”. Once you start it you can’t just declare it low priority and drop it.
OP
PowerTracManiac
Silver Member
Haha!
Dont fret, this will not be going away forever.
My next step will be to back off the nut and try a little grinding to see if that works......
Dont fret, this will not be going away forever.
My next step will be to back off the nut and try a little grinding to see if that works......
2manyrocks
Super Member
- Joined
- Jul 28, 2007
- Messages
- 9,521
I don't know if there is something to wedge against, but my method of removing rotary cutter assemblies is to use two opposing pairs of 2" oak wedges placed on either side of the shaft. The purpose of using two pairs is so the force of the wedges is even on both sides of the shaft and less likely to bind. Driving two wedges against each other also makes the force of the wedge more uniform and less binding.
Gravy
Platinum Member
I didn't see any mention of the set screw through the side of the hub. I hope that wasn't the cause of the broken shaft.
