Steering wheel spinner?
- Thread starter gwstang
- Start date
- Views: 4771
gwdixon
Elite Member
Yep, all my tractors and mowers have one. Very handy.
Don't scrimp when you buy it. I did and ended up spending twice as much because the cheap-o ones needed to be replaced.
Don't scrimp when you buy it. I did and ended up spending twice as much because the cheap-o ones needed to be replaced.
- Joined
- May 12, 2004
- Messages
- 13,257
- Location
- Northeast Ohio
- Tractor
- Kubota B2910, Cub Cadet Pro Z 154S, Simplicity 18 CFC, Cub Cadet 782
The one I have on the Kubota works ok ... but the clamp part which was chromed has rusted ...
davesl708
Elite Member
Yes. only use the spinner to steer.
dstig1
Super Member
- Joined
- Apr 7, 2010
- Messages
- 5,631
- Location
- W Wisc
- Tractor
- Kubota L5240 HSTC, JD X738 Mower, (Kubota L3130 HST - sold)
Yes, pretty much if my hand doesn't find the spinner, I have to stop to look down to find it before I can move. They should be standard. No point in running a tractor, especially with a loader, without one. I got the one with the kubota logo in it from Coleman online, IIRC. Works well, I just had to re-tighten it a couple times after install until it stabilized and was good to go for good.
Alan L.
Elite Member
I couldn't use my tractor without the spinner.
dragoneggs
Super Star Member
- Joined
- Jun 9, 2013
- Messages
- 14,548
- Location
- Seabeck, Washington
- Tractor
- Kubota BX-25D, Kubota Z122RKW-42
Yep, I even added a second as it was a gift. One is great... two don't hurt and work for me.
troutsqueezer
Veteran Member
How else are you going to work the loader with one hand and steer with the other?
Thanks everyone. You cracked me up. I thought one hand was for the cold "beverage" and you have to steer with your knees while using the loader.:crossfingers: Yeah, swmbo has already laughed at me for running into a few "unimportant things" with the loader. Takes some getting use too. :ashamed:
dragoneggs
Super Star Member
- Joined
- Jun 9, 2013
- Messages
- 14,548
- Location
- Seabeck, Washington
- Tractor
- Kubota BX-25D, Kubota Z122RKW-42
I thought I had it down with the bucket clearance... added a Piranha Tooth Bar and it actually reaches out an dings stuff even when I am paying attention! :confused3:
I once "accidentally" ran over some of her bushes and flowers, that were completely in my way and I had told her not to put anything there. Of course I did it when she was away visiting a relative at the time. The old 8N with a bushhog did pretty job...of course she did a number on me when she got home! Just about had to sleep in the barn for awhile...:irked:
dragoneggs
Super Star Member
- Joined
- Jun 9, 2013
- Messages
- 14,548
- Location
- Seabeck, Washington
- Tractor
- Kubota BX-25D, Kubota Z122RKW-42
Amazing what you can get done when the better half isn't around. No approvals necessary and no 'what the H E double hockey sticks are you doing comments'. I lose weight too!
Last edited:
AStanton
Platinum Member
I installed a spinner knob on the steering wheel of my B3030. I initially thought that it would be in the way. However, I found that it has been an asset, especially while being used when backing the tractor. If you install one, don't do what I did and get hung up on positioning it. Due to the power steering, the position of the knob always ends up on a different position on the wheel. If you position it at 9:00 o clock, it may be at 3:00 oclock next time you get on the tractor. One of my neighbors--an old retired truck driver--tried to remedy this problem on his old big Ford tractor--he installed three(3) separate spinners!
Attachments
texasjohn
Super Member
three spinners on my tractor...hydraulic steering ensures that the steering wheel wanders all over the place, thus just one spinner is never where you expect it to be.
one spinner on my RTV
DON'T get in the seat without at least one!
one spinner on my RTV
DON'T get in the seat without at least one!
Here are some similar links:
