My 6210 will start on just a couple turns but will stop after about three seconds. Then it has to crank and crank before it will start again. Up until recently, after it started the second time it would keep running. But now it dies again and takes another round of cranking to get it to fire again. It must not be getting fuel, correct? Can anyone point me in a direction to troubleshoot? Thanks.
Starting Problem on 6210
- Thread starter Believer
- Start date
- Views: 9206
Brimstone10x
Silver Member
Rubber fuel lines are always suspect these days, they dont make like they used too. mite just replace too be sure
Tx Jim
New Member
I agree as it sounds as if fuel is draining back to the tank.
wtt
New member
change all rubber fuel line. install check valve between fillter and tank. make sure all steel lines are tite. its a common problem with jd
fluttersmith
New member
- Joined
- Dec 24, 2007
- Messages
- 15
- Location
- East Texas
- Tractor
- Kubota M100GX, L3130, JD 6310, JD 3020, NH TZ24DA, JD 450E
Re: Starting Problem on 6210, now my 6310
JD 6310 with exact same problem. Let sit overnight, then crank next morning, starts promptly, dies after 2 seconds, then continue to crank for 20 seconds to resart and run normally. No visible signs of leakage from fuel lines.
What was the fix on your 6210?
JD 6310 with exact same problem. Let sit overnight, then crank next morning, starts promptly, dies after 2 seconds, then continue to crank for 20 seconds to resart and run normally. No visible signs of leakage from fuel lines.
What was the fix on your 6210?
gzfrt9
Member
- Joined
- Dec 19, 2010
- Messages
- 32
- Tractor
- 6615 Cab, 5520 4x4 Loader, 5520 Cab 2 wheel, 4400 Compact,
I have 6615 and had this same problem. I replaced braided fuel lines from primary filter to tank and it fixed the problem. I had no visible fuel leaks. No bubbles, once I replaced, I have not had the problem again. Also, my problem only showed up after tractor sat over night. If I got it running and shut off and restarted. I had no problem. Good luck!
