Square tubing question

[bones1]

I need a nice slide fit on some 2'' square tubing. I need to slide a 2'' piece into a 2.5'' piece with little slop.Just trying to get the wall thickness right to do this. Would a 2.5 with a 0.25 wall be what I need to take up the slack or would that be too tight?. Thanks for any info.
I see 0.12 ,0.1875 ,and 0.25 online.Unfortunately I have to get this online and can't test fit them.
After reading my post it seems like a really dumb question.

 

[Rio_Grande]

Not dumb, but I think you answered your own question. If I recall correctly 2 1/2 1/4wall tube would be 2 in id,

What I did in your situation was buy a piece of reciever stock, 2 inch slides inside perfectly. It cost a bit more but is also thicker wall I think 1/2 if I recall

 

[Cap-n-Cray]

Are you looking for trailer receiver square tubing? 2.5 X 2.5 X .250 is used for trailer receivers. What is the wall thickness of the 2 X 2 tubing? Only some size work. The corner radius sometimes bind.

Cary

 

[bones1]

0.1875 on the 2'' tubing.That receiver tube would be heavy and expensive but make a nicer job.Would a chart be available for this?. Order Mild Steel A36 Square Tube in Small Quantities at OnlineMetals.com

 

[SPYDERLK]

Are you looking for trailer receiver square tubing? 2.5 X 2.5 X .250 is used for trailer receivers. What is the wall thickness of the 2 X 2 tubing? Only some size work. The corner radius sometimes bind.

Cary

My question too. HF has standard receiver tube 18"L for $15. Item #97093-0AXH.
larry

 

[MrJimi]

The square tube will have a welded seam inside unless you purchase special tubing

 

[bones1]

MrJimi.......I forgot about the inside welds

 

[MrJimi]

agrisupply sells a receiver that is 6" long for less than than $10, I got 3 of them, and they work great

 

[SPYDERLK]

agrisupply sells a receiver that is 6" long for less than than $10, I got 3 of them, and they work great

see#5
larry

 

[bones1]

Some good metal information. 25 Hot Rolled Steel Forms