Spotted; 2305 and 2320 side by side

[Chris2520]

Tell em Gord the 2520 is a beast.....

Chris....

 

[RalphVa]

I drove both the 2210 and 4010 before deciding on the 4010. The 4010 is like the 2320 but with the same height ROPS as the 2210 had. The 4010 ROPS just fits underneath my garage doors, both the overhead doors in front and dual, side-opening doors down below. That was a real plus, but I'd have to go with the 2320 if given the choice today because I need the extra ground clerance and not have that hydro fan and cooler underneath like it is on the 2305.

Would like to have the postion control and new hood design on my 4010.

My 4010 seems a little tippy. Don't think the 2210 was any better in this aspect. Just need plenty of ballast out back and avoid dropping into holes on downhill side or going over humps on uphill side and go very slowly on any, even slightly, across hill runs.

Ralph

 

[kvjohndeere]

I can't speak for the 2320 but I can for the 2520. In comparison to the 2305, the new 2520 feels much more stable on the steep slopes. Extra weights hung off the front, and a RFM hanging off the back, it feels a lot better than the 2305 with a 62C deck hanging from the belly.. just MHO.

For example.. on one spot on my ditch, I had to go really really slow with the 2305 due to the slope. If I stopped on this spot and moderately rocked the tractor from side to side, I could feel it sway. Without a doubt, it would tip if I rocked hard enough. On the same spot with the 2520, it feels PLANTED.. it generally feels like it would take a lot more force for it to start to sway and finally start to tip. This has given me a much greater sense of confidence when cutting on steep slopes.

GN

I agree The 2320 Are about the Same asFar as Frame & differetial s & height really only difference is The Diesel engines ! I compare Tha width of the 2320 & the 2520 There is only 1.6 " in Width difference I thank it will handle cutting a 40 degree angle with ease But I always make sure the ground is dry ! Take care thanks for the feedback ! kvjohndeere

 

[kvjohndeere]

I drove both the 2210 and 4010 before deciding on the 4010. The 4010 is like the 2320 but with the same height ROPS as the 2210 had. The 4010 ROPS just fits underneath my garage doors, both the overhead doors in front and dual, side-opening doors down below. That was a real plus, but I'd have to go with the 2320 if given the choice today because I need the extra ground clerance and not have that hydro fan and cooler underneath like it is on the 2305.

Would like to have the postion control and new hood design on my 4010.

My 4010 seems a little tippy. Don't think the 2210 was any better in this aspect. Just need plenty of ballast out back and avoid dropping into holes on downhill side or going over humps on uphill side and go very slowly on any, even slightly, across hill runs.

Ralph

You took The words right of my mouth ! Thanks fellow Virginian ! Have Merry Christmas RalphVa

 

[JiminGa]

see, that's why I love these forums...I can ask guys that have made the same upgrades I am considering and learn before I make a ten thousand dollar mistake, or great investment...good to here the 2320 and 2520 seem to be more stable, now if we can get more rain!

 

[kvjohndeere]

see, that's why I love these forums...I can ask guys that have made the same upgrades I am considering and learn before I make a ten thousand dollar mistake, or great investment...good to here the 2320 and 2520 seem to be more stable, now if we can get more rain!

Amen Jim in Ga We could use alot more up Here in The heart & soul & The capitol of The Confederacy Im about 20 miles South Of Richmond Va. Ole Dixie Has Been taken a beaten this year as far as rain ! We are still far Behind in Rain ! & the weather is crazy I is susposed to get close to 70 degrees here tommorrow on Christmas day ! Guys like me Give guys like you alot of learning so you wont make the same mistakes we did ! Oh well we live & learn ! Take care Fellow southerner !

 

[unreconstructed]

Hope you guys holding the fort in Eastern Dixie get some wet stuff. Have had plenty out here in the western frontier (West Texas) of our beloved Southland.

Like the fella in Northfield, I saw a 2305, 2320, and 2520 sitting side by side at a dealership. Had been mulling over the 2305, but being able to sit on each machine made my mind up in a hurry--at least about eliminating the 2305. Went with the 2320 just due to price difference--reading all the threads makes me wonder I shouldn't have gone 2520, bit I really like the 2320 so far so all is well.

On a side note, if the James boys could hit Northfield again, I would ride with them if they would agree on taking the JD house instead of the bank!!!
Just kidding.

 

[Runner]

I regularly mow a 20 degree side slope with my 2520 and haven't rolled it (yet). Actually, it feels stable to me in that situation which was a relief.

My dealer suggested that the R4 tires help a litte on the stability too, becauses of their more "square-shouldered" cross-section, as opposed to the more rounded R3's. Don't know if it really makes a diff., but it works for me.

 

[megotatractor]

If anyone sees a short,round fellow riding a sleigh let him know he forgot to leave my new tractor under the tree the other day!!

 

[Runner]

He couldn't get his ride started. I heard he was using an old, beat up F150 this year....