BRBurns
Silver Member
I added a diverter valve and a HTL to my 4300. The diverter valve allows me to keep the MMM lift attached and the HTL attached at the same time. I've had the HTL installed now for a few weeks, but it is a little spongy. If there is allot of force put on it it will move about an inch. I've ran it completely in and out many, many times so I think all the air would have worked itself out by now. It doesw not have a check valve because I didn't think I would need one. The HTL is from fit right Hydraulics and seems to be of good quality, and I don't think it is leaking internaly since it always comes back to the same spot when the forces are not on it.
Any Ideas?
Any Ideas?
