WranglerX I agree with you 100 percent. That is a fool proof way. But my point is Tractor supply employees are not in tune with us who use this equipment. And you would be wasting your time to show them this.As others have said, get ID of seal location in gear box housing and OD of the shaft also depth of seal housing........ Inexpensive digital calipers should be accurate enough....
Take numbers to good bearing supply house.... OR spend some time online (MCMASTER?)
4 in. Digital Caliper
Amazing deals on this 4In Digital Caliper at Harbor Freight. Quality tools & low prices.www.harborfreight.com
McMaster-Carr
McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.www.mcmaster.com
Southernmfg bushhog oil seal replacement
- Thread starter Ky farmer16
- Start date
- Views: 1544
cathy liebchen
Platinum Member
New gearbox is cheap
I just don’t have big budget
old and tired
Veteran Member
Fill the leaking gear box with corn head grease... It will work just fine.
WinterDeere
Super Member
- Joined
- Sep 6, 2011
- Messages
- 6,234
- Location
- Philadelphia
- Tractor
- John Deere 3033R, 855 MFWD, 757 ZTrak; IH Cub Cadet 123
I wouldn't even bother with TSC for a seal. Every town has a bearings and drives place. Their name will usually include "bearings" or "drives", or "gears". Here's mine: Frank Callahan Co., Inc. Colmar Branch Page
Now go find yours! These guys will take one look at your old seal, double check with your measurements, and give you the right part... all likely under $15.