D
Deleted member 216442
Guest
If you have your 3 pt hitch lifted all the way up try setting it a bit lower, then try operating your FEL. It may affect it.
Slow fel
- Thread starter guitarman
- Start date
- Views: 2350
OP
guitarman
Silver Member
- Joined
- Dec 15, 2015
- Messages
- 127
- Location
- Coarsegold, Ca
- Tractor
- Jinma 454// other equipment husqvarna rancher 61 chain saw & model 460 both with 24 " bar, 2 husq trimmer, greemworks 40volt trimmer and pole saw. 20 ton wood splitter, various welders metal saws and drill press
The knob under seat controls 3 pt. And fel moves and operates same speed no matter if 3 PT is up or down I have even tried letting it down as I operate fel no difference. Even my tractor guy I got Angus from said it's just the way it is has to do with the volume of the Chinese pump.
ch1ch2
Veteran Member
Rereading some of the posts; Unless I missed something, you do not say that it was faster, only you think it should be faster because your son's is faster.
Is that correct?
If so, I still think gauges are needed. I got gauges with fitting for under $100. I put them in the loader disconnects.
If you are not getting enough pressure, it might be an adjustment on the relief valve. If it is by passing inside a cylinder then you will know which one to take off, before it makes more metal to contaminate you system and do more damage.
Is that correct?
If so, I still think gauges are needed. I got gauges with fitting for under $100. I put them in the loader disconnects.
If you are not getting enough pressure, it might be an adjustment on the relief valve. If it is by passing inside a cylinder then you will know which one to take off, before it makes more metal to contaminate you system and do more damage.
OP
guitarman
Silver Member
- Joined
- Dec 15, 2015
- Messages
- 127
- Location
- Coarsegold, Ca
- Tractor
- Jinma 454// other equipment husqvarna rancher 61 chain saw & model 460 both with 24 " bar, 2 husq trimmer, greemworks 40volt trimmer and pole saw. 20 ton wood splitter, various welders metal saws and drill press
Haven't tried adjusting just talked to one I bought tractor from he has been dealing in Chinese tractors and doing equipment repairs for many years and says the pump on these doesn't put out the rate of flow to make system quick. I check and change the filters no metal really and power is not a problem.
