Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 7,047
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
TMGT.
PM sent.
PM sent.
Shield gas mixer
- Thread starter TMGT
- Start date
- Views: 5572
OP
TMGT
Elite Member
Was able to pick up a Smith mixer for a decent price, need to get some outlet adaptors for my regulators so I can hook it up and test it out.
Unfortunately it had a bit of a hit in shipping, appears to only be cosmetic but want to hook it up and test it to make sure it works.
Unfortunately it had a bit of a hit in shipping, appears to only be cosmetic but want to hook it up and test it to make sure it works.
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 7,047
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
Nice
. I hope it IS only cosmetic damage.
. I hope it IS only cosmetic damage.
OP
TMGT
Elite Member
Me too, was able to get some adaptors today so plan on testing it out later. I dont have any straight CO2 so just going to hook up some C25 and argon and make sure it doesn't leak. Wont be able to check the calibration until I make it over to my uncle's shop and use the gas analyzer.
OP
TMGT
Elite Member
Hooked up the mixer to c25 and Ar bottles as I don't have a C02 bottle yet, seems to be working so hopefully it's good to go. Apparently I'll be getting a little money back from the insurance for the damage, once its finalized I'm going to try to straighten the case out.
