Securing tractor to trailer

/ Securing tractor to trailer #1  

NewToy

Veteran Member
Joined
Jun 14, 2005
Messages
1,043
Location
Ohio
Tractor
'05 Farmtrac 270DTC
Having trailered my tractor a few times I always run into a hassle securing the front axle with chains. I use the rear drawbar for securing the rear and run the chains around the axle in a way as to not skin all the paint off.
The front of my tractor (FarmTrac 270) has a 1/2" thick steel plate , part of the frame that has four holes that I assume are for a weight rack. I was wanting to weld a pintle hook to another plate and bolt it to the front plate. Then I would just run the chain through the pintle hook as the front attachment point. I figure it would also double as an easily accessible tow hook in case of getting mired in the mud.
Do you think this would work OK? I would weld the pintle hook on in a vertical orientation as opposed to the usual horizontal manner.

John
 
/ Securing tractor to trailer #2  
I bought 2 of these tie down hooks and welded them to the tractor loader frame. Now I slip the chains through these on the tractor and the larger ones on the trailer and secure with a ratchet binders.
 

Attachments

  • Tow hooks.JPG
    Tow hooks.JPG
    41.2 KB · Views: 608
/ Securing tractor to trailer #3  
Anything solidly fastened to the frame will be better than chaining the axle itself. I use a loop weled to a 3" chanel iron bolted to the front of my Two-cylinders.
 
/ Securing tractor to trailer #4  
I had a hole on each side of my frame that I put a short piece of 3/8" grade 70 chain and a grab hook. It is attached to the frame with a 3/8" menda -link through that hole. It is only 3 links long so it just hangs there when not in use. On the rear near the draw bar my tractor had 2 3/8" grab hooks welded from the factory for pulling, safety chains, ect.

Chris
 
/ Securing tractor to trailer #5  
Also keep in mind, it's not legal to use a chain from one side, through the loop, to the other side. DOT regulations (apply to ALL hauling, not just commercial) require a separate chain on each corner.
 
/ Securing tractor to trailer #6  
Chadoincolo while that is a good though I'm not sure it is correct for lower weight tractors (equipment) like most folks here at TBN have. At least that is what I remember. Someone more up todate than I perhaps can clear that point up!
Leo
 

Marketplace Items

2012 Chevrolet Sonic Sedan (A61569)
2012 Chevrolet...
Box of Transport Ratchet Straps (A59230)
Box of Transport...
2013 MAXX-D BUMPER PULL TRAILER (A60736)
2013 MAXX-D BUMPER...
Case-IH 165 Puma (A57148)
Case-IH 165 Puma...
2021 INTERNATIONAL MV607 (A60736)
2021 INTERNATIONAL...
2007 CHEVROLET 3500 DUALLY 4X4 DIESEL TRUCK (A59575)
2007 CHEVROLET...
 
Top