Rushy11
New member
Hi!
I'm going to build my own Box blade and just start to make up some draws and study a lot of pictures and read a bit here...
Back home in Germany i've got a 19hp Kubota B1500. I thought to make a 1200mm (4ft) wide box blade with hydraulic shanks and a hydraulic tilt. Not to sure yet, how to design the hydraulic tilt, but it won't be very hard. Unfortunately, now one in Germany has got a box blade and you can't get parts for it either. Just a few questions:
-are these shanks strong enough? https://www.industriehof.com/frm_middle.php?page=1&lang=en&grp=5&grpid=68&ktg1=139&ktg2=627 the one with the 3 holes in it
- I'd like to curve the rear wall to get the dirt "rolling", wich radius would be good if the side plates are about 300mm (1ft) high?
Cheers
Rushy
I'm going to build my own Box blade and just start to make up some draws and study a lot of pictures and read a bit here...
Back home in Germany i've got a 19hp Kubota B1500. I thought to make a 1200mm (4ft) wide box blade with hydraulic shanks and a hydraulic tilt. Not to sure yet, how to design the hydraulic tilt, but it won't be very hard. Unfortunately, now one in Germany has got a box blade and you can't get parts for it either. Just a few questions:
-are these shanks strong enough? https://www.industriehof.com/frm_middle.php?page=1&lang=en&grp=5&grpid=68&ktg1=139&ktg2=627 the one with the 3 holes in it
- I'd like to curve the rear wall to get the dirt "rolling", wich radius would be good if the side plates are about 300mm (1ft) high?
Cheers
Rushy
