czechsonofagun
Elite Member
I could not resist to come back to my old stomping ground to show off 
First, this is what it does:
First, this is what it does:
Sawmill
- Thread starter czechsonofagun
- Start date
- Views: 29246
OP
czechsonofagun
Elite Member
It is based on an I beam I got for free and the whole idea is taken from Logosol.
OP
czechsonofagun
Elite Member
Log moves up with 1" ACME rods.
The log dogs I may need to change or improve, but it works for now.
The log dogs I may need to change or improve, but it works for now.
OP
czechsonofagun
Elite Member
Cheap rulers help setup the thickness, 1 3/8" move up gets me 1" board.
OP
czechsonofagun
Elite Member
24" bar with ripping chain will need an end support, it shakes bit too much.
I tried to use whole 372XP clutch assembly, but it would slip on slow down - this is the outer clitch piece welded to a spindle. It gives me the option to replace the chain sprocket rim as needed.
I tried to use whole 372XP clutch assembly, but it would slip on slow down - this is the outer clitch piece welded to a spindle. It gives me the option to replace the chain sprocket rim as needed.
OP
czechsonofagun
Elite Member
And mandatory tractor content
OP
czechsonofagun
Elite Member
The whole electrical setup has to be updated, also the oil delivery is lacking - gravity feed only now - probably will have to get some kind of an oil pump.
Buggs67
Veteran Member
I like it. I'm assuming you have a ripping chain on there. How is the chain oiled? How many HP motor?
OP
czechsonofagun
Elite Member
The motor is 6hp and yes, using ripping chain.
Oiled is gravity fed and the bar has extended hole to get the oil to the chain, but I think it needs more pressure than gravity to lube better.
Oiled is gravity fed and the bar has extended hole to get the oil to the chain, but I think it needs more pressure than gravity to lube better.
Egon
Epic Contributor
Your back Prokop!
Nice setup. Weld made. Have you got a good supply of timber.
Nice setup. Weld made. Have you got a good supply of timber.
