roto cutter

[agee]

Help need to buy rotary cutter for 1026r need help with size 4' or 5' Thanks

 

[Gary Fowler]

HP wise it should pull a 5' shredder but weight might be a problem. According to tractordata it only lifts about 640 pounds 24" from the pins so considering that a 5 foot BH will be at least 5' from front to back minus the tail wheel, perhaps 500 pounds would be about the max it would be able to handle efficiently. If you get a light duty BH in 5 foot, it may be able to handle it properly.

 

[Gary Fowler]

Considering the weight of around 500 pounds for safe operation (Tractordata lists 640 at 24" behind the pins), if you can find a 5 foot bush hog close to that weight, it should handle it OK. Rule of thumb is 5 HP per foot so HP wise you should be right at the limit. You can always overlap a bit in heavy cover if the engine is stalling a little and still have the full 5 Foot for light cover.

 

[Sawyer Rob]

18 pto HP, it should run a 5', UNLESS you have very heavy grass to mow...

SR

 

[whis]

I will be the odd ball 4 foot is plenty big for that machine

 

[nybirdman]

I would say a four footer for that machine.I think a five footer would "bog" in anything but light stuff.Also too much weight out the back.
I have a medium duty five ft.Bush_Hog branded BH and believe it to be too much for the BX/1 series JD>

 

[EverythingAttachments]

Our ETA 48" Brush Cutter would be great on your tractor.

 

[Henri88]

I would also suggest the 4'. This is what I use and would not risk a 5' although I have not tried one.

 

[HEC]

I have a med. duty 5 ft. on my 2650 which only has about 19 hp. at the pto and it is does fine . I only cut tall grass with mine , I sure wouldn't want to do any more then that . The dealer recommended the 5 ft. for what I was using it for . I did put weights on the front end as I don't have a loader for that tractor .

 

[JKR]

I would get the 4 footer.