Request for 1510 pictures

[AlfaRs]

Haven't been able to find one. As soon as I get around to it I'm going to make something. I think I will make one that works like a receiver hitch. That way it will be more flexable. I'll post some pictures when I get it done.

 

[ChuckT]

I studied our 1510D and the drawbar is too short to use for anything other than part of the 3 point hitch - so I'm going to see what I can get made up.

So far the most practical solution looks like a "Z" shaped extention. About 4" wide by 1/4" thick and maybe 14" long overall. Two holes punched in one end (for bolts to fasten it to the existing drawbar), a slope down (6" or 8" drop), than a straight extention with a 1" hole for the trailor ball with rings welded on each side for the chains.

cvt

 

[AlfaRs]

I'm thinking along the lines of a plate made to fit the existing bolt location at the bottom of the case with a box section (like a receiver hitch) welded to it extending the appropriate length back (need to measure yet). I figure that way I can use a standard truck hitch. That way I can pick one with the appropriate rise/drop for the trailer/stuff that I drag.