I have a 2014 xr3037h, and I need to replace 2 hydraulic lines. One end is mounted way inside the firewall. How do you get to them? I I thought maybe I would pull the hood tomorrow, and see if that’s possible. Anyone else done this and have advice? Thanks in advance.
Replacing hydraulic lines
- Thread starter kenjohn63
- Start date
- Views: 1089
https://www.tractorbynet.com/forums/ls-tractor-owning-operating/401751-hydraulic-line-failure.html?highlight=Hydraulic+Line
They can be a pain. FYI if you have a new line made up the 90* angle may not be as long. The one I had made was a tad shorter but worked. Make sure you get them threaded on by hand first. I had to remove the hood so you'll need someone to help you lift it off and the hood bracket. Also took the one fuel line loose to get to the hose.
They can be a pain. FYI if you have a new line made up the 90* angle may not be as long. The one I had made was a tad shorter but worked. Make sure you get them threaded on by hand first. I had to remove the hood so you'll need someone to help you lift it off and the hood bracket. Also took the one fuel line loose to get to the hose.
newbury
Super Star Member
- Joined
- Jan 8, 2009
- Messages
- 14,855
- Location
- From Vt, in Va, retiring to MS
- Tractor
- Kubota's - B7610, M4700
Thanks for the wrap up, any further details?
They are power steering lines. Out of the 4 connections, there is only 1 that is easy to get at. The two on the firewall were really recessed in there. Took the hood, hood bracket, and some other minor stuff to get at them. Then we heated and bent some wrenches to get in there. Only problem was, once you bent the wrenches, you couldn’t get enough torque to break them loose. Finally we were able to get the open ends on partly. We then with a pipe on the end , we’re able to get them. If there was a way for the mfg to mount that male connection in the firewall out a bit, it would be a lot easier. I even called a technician at a LS dealer, and he said there is no easy way.
