3-Point Hitch Re hydraulic 3point hitch issues
- Thread starter mooseman1
- Start date
- Views: 791
/pine
Super Star Member
- Joined
- Mar 4, 2009
- Messages
- 12,450
Is there a front end loader attached ?...although the dropping suggests an internal (3ph) cylinder issue...
TMGT
Elite Member
Is the handle moving or is the 3pt bleeding down?
Make sure the feedback rod for the 3pt is intact and working correctly also, had this problem on an older kubota B7200 and adjusting the feedback rod correctly fixed the dropping issue.
Not sure if the adjustment procedure is listed in the owner manual or if you'll have to get a workshop manual.
That model of tractor also had some jerky 3pt issues when new but should hold position.
Make sure the feedback rod for the 3pt is intact and working correctly also, had this problem on an older kubota B7200 and adjusting the feedback rod correctly fixed the dropping issue.
Not sure if the adjustment procedure is listed in the owner manual or if you'll have to get a workshop manual.
That model of tractor also had some jerky 3pt issues when new but should hold position.
Actually the handle kicks back when using it and the hitch also lowers by itself when not in use .
TMGT
Elite Member
There's a friction nut that should keep the handle in position, sounds like it might be a little lose. If it's kicking back and lowering on its own the rod is out of adjustment, even with a leaking cylinder it should still maintain its height when running.
I had the same problems on a B7200 with position control, the handle would drop until I tightened up the pivot, would also kick and fight until I got the feedback rod adjusted right.
I had the same problems on a B7200 with position control, the handle would drop until I tightened up the pivot, would also kick and fight until I got the feedback rod adjusted right.
Last edited:
