Rabbit Speed

[caspers62]

I have a 08 5600D and the high speed has quit working, everything else is working. Work mode works, when I push the button on the travel selector handle nothing lights up or switches. I have checked the switch itself and it seems to be working. Any ideas???

 

[Spudgunner]

You've probably already done this, but you might have some error codes stored. IIRC that little card in the cab has the procedure for accessing the codes. I think you hold down the headlight button...but I don't recall for sure.

 

[caspers62]

I'll have to check that. Thanks

 

[caspers62]

There are no error codes. It read "none" .Still digging into it.

 

[FlyingSniper]

Don't know why it would stop working if it was before, but look at the control panel setup (page SA-6 in the operation manual) under two speed set up.

 

[caspers62]

That was it, don't know how it got turned off but going into that section and basically rest it to where it should be. The two speed works!! Thanks