Question on iMatch

[Gizmo2]

I am making a rear three point hitch ballast. I have a steel plate that measures 30 inches across and will need to mount the lower 3PH pins in from the edges of the steel plate so that I will stay I-Match compatible. Can someone give me the distance I need to allow for the I-Match lower hooks to clear the plate? How far away do I need to mount the pins from the steel plate? I plan on using two pieces of 5/16 angle iron 4 inches long that will be welded to the plate for the pin mounts.

 

[jdbower]

Here you go...

 

[Gizmo2]

jdbower,

It does not show the measurement I need.

 

[truckie36]

Is this what you are looking for? It's about 1 1/8"

 

[Gizmo2]

Is this what you are looking for? It's about 1 1/8"

That's it, Thanks