PT mounting plate question

[SpringHollow]

I have used an adjustable top link and broken 2 of them in half, shearing where the cross handle is.

Increasing PT1850 FEL Tilt Range

I have never been happy with the tilt range on my PT's FEL. It may be only an issue with my bucket since it is a Lackender bucket, not a PT bucket. My original tilt range was 90ｰ which let me either carry things well or dump well but not both. So I made bolt-on adapter plates to extend the...

www.tractorbynet.com

 

[PowerTracManiac]

Below is a thread that has some more information for you on forks/mounting plates. My setup is post number 6 with some pictures. I use the forklift frame with a PT welded adapter plate and then I purchased an add a grapple that goes over the forks for moving logs, etc. Works well.

Add A Grapple?

Group, Long question on bucket grapples. I have an extra bucket (long story) and am thinking of adding a grapple to it. As I was looking at different Add-A-Grapples I noted that Titan’s Add-A-Grapple cost more then their Root Grapple (assuming I would just add a homemade PT mounting plate). So...

www.tractorbynet.com

 

[woodlandfarms]

I make my own adapter plates. Very simple design. I have used an adjustable top link. It was broken a number of times.