Chains Problem with front chains on L35

Telstar2112 · Dec 31, 2013

Posted this in the wrong section so re-posting here, sorry for the double post.

I'm mounting chains on my kubota L35. On the fronts I finally got them mounted up nice and tight and even but then I noticed that if I turn the wheel all the way the chains rub on the tie rod. Is the solution "just don't turn all the way" or is that likely to cause a problem? I have already spent a lot for 2 link rear chains, rear wheel spacers, and the front chains so I am hoping for a cheap solution.
Thanks,
Steve.

DT86 · Dec 31, 2013

You could adjust the steering stops out.

Telstar2112 · Dec 31, 2013

DT86 said:
You could adjust the steering stops out.

Ha! Thats what my wife said! I was wondering if there was such a thing. Is it obvious how to do this, I have not looked at it yet as it was snowing a lot, freezing cold and I dont have a garage yet (almost finished).

Chilly807 · Dec 31, 2013

If you have them, I think they're just bolts threaded into an ear on the steering knuckle, the head of the bolt acts as a stop. If you do adjust them, be sure to measure exactly where they were before you moved them, you'll want to put them back in the spring.

Sean