Power Beyond Port
- Thread starter PRranch
- Start date
- Views: 1229
Michael In Tennessee
Gold Member
No clue. I would bet you don't have near the hydraulic flow to do it, so it would be moot anyway. Find another way.
ericm979
Super Member
- Joined
- Nov 25, 2016
- Messages
- 5,822
- Location
- Santa Cruz Mountains CA, Southern OR
- Tractor
- Branson 3725H Deere 5105
A Ford 4500 industrial has 23gpm on the loader circuit. That might be enough to run a mower. I'd do the calculations first (or look up the mower manufacturer's recommendations) before going down this road too far.
The PB line should be a line from the loader valve to the rear 3pt. Often the 3pt cylinders are in the transmission case, at the very back.
You may want to add a rear remote valve that has a detent and a motor spool. The mower manufacturer should say what sort of valve to use.
The PB line should be a line from the loader valve to the rear 3pt. Often the 3pt cylinders are in the transmission case, at the very back.
You may want to add a rear remote valve that has a detent and a motor spool. The mower manufacturer should say what sort of valve to use.
Michael In Tennessee
Gold Member
I stand corrected. Seems like enough flow.
I found an old thread that might be helpful...
https://www.tractorbynet.com/forums/new-holland-owning-operating/110238-4500-remote-hydraulics.html
I found an old thread that might be helpful...
https://www.tractorbynet.com/forums/new-holland-owning-operating/110238-4500-remote-hydraulics.html
Dave M7040
Elite Member
- Joined
- Dec 10, 2012
- Messages
- 2,757
- Location
- Williamstown Ontario Canada
- Tractor
- Kubota M7040 Nuffield 465
Often the simple answer is backwards to what you are inclined to think.
By a new control valve with a power beyond port.
Install the new control valve BEFORE your other control valves and feed the old valves from the power beyond port on the new valve.
Dave M7040
By a new control valve with a power beyond port.
Install the new control valve BEFORE your other control valves and feed the old valves from the power beyond port on the new valve.
Dave M7040
Tropical Jack
Bronze Member
My old Ford Industrial tractor with loader had a completely separate hydraulic system for the loader. The pump was in the very front of the tractor, powered by a jack shaft from the crankshaft. The tank was an integral part of the loader.
Jack
Jack
