HawkinsHollow
Veteran Member
BRAVO!! Great job, looks amazing. A little rip rap on either side of the stairs and it will blend right in. My vote is these stairs are going to outlast most of us here.
Pouring steps down to the creek/swimming hole...nope, never done it before!
- Thread starter MotorSeven
- Start date
- Views: 21570
OP
MotorSeven
Elite Member
True......we have a close group here, they are all stand up guys, known some for over 40+ years. There is a serious value in true friends.....
ultrarunner
Epic Contributor
- Joined
- Apr 6, 2004
- Messages
- 28,771
- Tractor
- Cat D3, Deere 110 TLB, Kubota BX23 and L3800 and RTV900 with restored 1948 Deere M, 1949 Farmall Cub, 1953 Ford Jubliee and 1957 Ford 740 Row Crop, Craftsman Mower, Deere 350C Dozer 50 assorted vehicles from 1905 to 2006
Sad but my true friends have all departed… then they were always older to much older and took me under their wing as mentors and friends…
Lucky to have the 5 for the decades I did…
Last edited:
2manyrocks
Super Member
- Joined
- Jul 28, 2007
- Messages
- 9,482
Pretty good friends to show up in the late summer heat to pour a lot of concrete.
AnotherBueller
Gold Member
Especially the face. I've seen 1X8 lumber bow out from the pressure, and if the concrete was too wet, it can flow out into the step below.
EddieWalker
Epic Contributor
I just found this thread and enjoyed reading it this morning. I had a lot of ideas of what should be done, but none of them where as good as what you actually did.
The only thing I would suggest is getting a concrete blade for a 4 1/2 inch grinder and rounding off all the edges on your steps if you wanted a smoother finish.
For a railing, I've seen metal pipe with a T at the end used in hostile environments that seem to have been there for decades. You run a line through the T at the top of the pipe to hold on to, and if the line breaks, you can easily replace it.
The only thing I would suggest is getting a concrete blade for a 4 1/2 inch grinder and rounding off all the edges on your steps if you wanted a smoother finish.
For a railing, I've seen metal pipe with a T at the end used in hostile environments that seem to have been there for decades. You run a line through the T at the top of the pipe to hold on to, and if the line breaks, you can easily replace it.
