Post your Branson at work. Picture thread
- Thread starter Number15
- Start date
- Views: 44893
Slowpoke Slim
Elite Member
- Joined
- Jan 6, 2017
- Messages
- 3,620
- Location
- Bismarck, ND
- Tractor
- Husqvarna YTH24V48 riding mower, Branson 3725CH
Looks like one of your walls fell off of your outhouse!
Slowpoke Slim
Elite Member
- Joined
- Jan 6, 2017
- Messages
- 3,620
- Location
- Bismarck, ND
- Tractor
- Husqvarna YTH24V48 riding mower, Branson 3725CH
I used mine yesterday to haul an outdoor wooden swing into the garage so I could refinish it.
Not exactly "taxing", but it was more than I could carry by myself.
Love those forks.
Not exactly "taxing", but it was more than I could carry by myself.
Love those forks.
Its ok, in the country, hahaLooks like one of your walls fell off of your outhouse!
tacticalturnip
Elite Member
The quality of your loader is superb, it always impresses me when you post your machines.
ptsg
Super Member
Thank you! If I was doing it again, I would stick with my original plan of building the cylinders with 50 mm bore instead of 60 mm. I don't need the ridiculous amount of lifting capacity this thing has but could use a little bit more speed.
Tntcwg3
Member
I'm in complete agreement, part of the reason I bought my BB 4035H (3515H) was to save what's left of my back. It doesn't take much to throw it out if I get in the wrong position or overextended.
Hendey T&G
Bronze Member
Still working on my shed. I think I'm going to start calling it a barn from now on. That's a triple 2x10 header the Branson made easy to install.
