Obcop43
New member
Hello, does anyone know how to make sure I don't over fill trans/gear fluid on my TO35 model, thanks
I read something about removing some screws?
I read something about removing some screws?
Oil & Fuel Oil
- Thread starter Obcop43
- Start date
- Views: 843
Jerry/MT
Elite Member
- Joined
- Feb 2, 2008
- Messages
- 3,141
- Location
- North Idaho-The Palouse
- Tractor
- New Holland TD95D, Ford 4610 & Kubota M4500
One way is to find the oil capacity in the owners manual and after draining completey, only put in the specified ammount. I believe you should just have fluid coming out of the lowest bolt hole on the right side access plate when the oil level is correcct. And then there is the dipstick in the same access plate.Fill it about 90% and wait a few hours for the fluid to get into all theee sumps and then top off. DO NOT use gear oil. Use only UTF or GL-1 transhydraulic fluid.
Last edited:
