No PTO output

[hbaird]

Jinma 200 2005
My PTO has stopped driving the hydraulic pump connected to it. I can shift the speed lever 1000/off/540 and see a little movement on the PTO output shaft but no power to the shaft.
The pump will turn freely by hand. It was working a few months ago when I used it last. Any suggestions?

 

[Affordable]

What about the Main PTO engagement lever by your right foot ? If they are both engaged then it may be a broken Shift lump or a PTO clutch adjustment

Tommy
Affordable Tractor Sales
"Your Jinma Parts Superstore"
Home of compact Jinma, Foton, and Koyker Tractors and Parts, Wood Chippers, Backhoes - Affordable Tractor Sales Company

 

[hbaird]

Is it the lowest lever? Almost on the floor? I tried it in the dark with the engine off. It is at what looks like the high position. I wll go back out in the morning. That lever is most likely. It was working and there has been no problems other than no drive.
Thank you Tommy.

 

[PILOON]

Might simply be an adjustment of the lever that engages the pto gears.
or as happened on my FWD lever, the roll pin that locked the lever to the shift shaft sheared off. (was simple enough repair)

 

[hbaird]

It was the PTO Engagement lever. I don't think I ever have used it. I must have pulled it up by mistake.
Thank you again Tommy.

 

[Affordable]

No problem glad it was a simple and easy fix.I cannot tell you how many times customers have brought tractors to our shop on a trailer that said the PTO stopped working and the lever in the back was in N instead of 540/1000 ,prob. when they were cleaning up the tractor

Tommy
Affordable Tractor Sales
"Your Jinma Parts Superstore"
Home of compact Jinma, Foton, and Koyker Tractors and Parts, Wood Chippers, Backhoes - Affordable Tractor Sales Company