New project: Front Snow Plow

   / New project: Front Snow Plow
  • Thread Starter
#41  
Added a home made 1/4" thick x 3" Carbon Steel cutting edge to the plow.

Drilled it dead center, so it is reversible.

Mild steel would have probably been fine, but, this was available and not much more $$$

Carbon Steel Cutting Edge
 
   / New project: Front Snow Plow
  • Thread Starter
#42  
To finish up this thread and project, here is the final-final picture, in action.


More info can also be found in the thread about the rubber snowplow edge.
Snow Plow Test

This reply is to simply tie this thread to the other thread.
 
   / New project: Front Snow Plow
  • Thread Starter
#45  
LBrown59 said:
How do you like your tiller?

I have a 48'' KK tiller and can use it on my BX23 or either of my BX1500S.


The 48" KKII (TG) gear drive tiller is great. I've done quite a bit of landscaping with it recently, it runs fine.

The rating systems used by implement manufacturers is sometimes skewed. In this case they tell you minimum of 20 HP PTO for the 48" KKII. I am having no problems with power, I have power to spare.
 

Tractor & Equipment Auctions

2014 Doosan DA30 (A51039)
2014 Doosan DA30...
2025 Kivel 48in Forks and Frame Skid Steer Attachment (A50322)
2025 Kivel 48in...
2014 PJ 24+6 T/A GOOSENECK (A50854)
2014 PJ 24+6 T/A...
2014 CATERPILLAR 336FL EXCAVATOR (A51242)
2014 CATERPILLAR...
REYNOLDS 100 - 8 YARD PULL TYPE SCRAPER PAN WITH DRAWBAR (A51039)
REYNOLDS 100 - 8...
RIGID 150 PSI AIR COMPRESSOR (A50854)
RIGID 150 PSI AIR...
 
Top