new member

Yanmar140D · Dec 6, 2007

MJPetersen said:
Jim,
Welcome to TBN. That is a nice looking tractor. I am not familiar with a 140D, but if it is like the other products that I have seen from Yanmar it is quality. Yours looks almost new!!

I would love a closer pic of how the ROP and the PTO guard are attached if you get a chance.

Again welcome!

Mike

Mike, I'll snap a few photo's and post them here. Thanks, Jim

Yanmar140D · Dec 6, 2007

MJPetersen said:
Jim,
Welcome to TBN. That is a nice looking tractor. I am not familiar with a 140D, but if it is like the other products that I have seen from Yanmar it is quality. Yours looks almost new!!

I would love a closer pic of how the ROP and the PTO guard are attached if you get a chance.

Again welcome!

Mike

Mike, here are a few photo's of the rops mount/pto cover setup. The rops mount wraps around the end of the frame rail as well as the sides and is held is place by some large bolts. Hope this helps.

MJPetersen · Dec 6, 2007

Thanks Jim for the pics. It looks like this was constructed after-the-fact. Certainly looks sturdy enough. What does it have 2 or 3 bolts on the top, one from the side and then one from the back? 4 times 1/2 inch (???) bolts on each side will take alot.

Thanks again,

Mike

greatrandini · Dec 6, 2007

thanks for joining and for the pics. See ya round!

Yanmar140D · Dec 6, 2007

MJPetersen said:
Thanks Jim for the pics. It looks like this was constructed after-the-fact. Certainly looks sturdy enough. What does it have 2 or 3 bolts on the top, one from the side and then one from the back? 4 times 1/2 inch (???) bolts on each side will take alot.

Thanks again,

Mike

Mike, Looks like three on the side, three on top and one from the back. Its rated for 3500 lbs, serial # CP 855-10-2. It was made by Custom Products of Litchfiled, Minn. Their still in business. Here's the link: Custom Products of Litchfield. Thanks, Jim