Tractorbill
New member
I'm in need of a shaft assy for FEL part #70050-01113. It is the back half that slips over the crankshaft on L245DT. Or what other options to keep this FEL working would be appreciated.
Need Shaft Assy for FEL - L245DT
- Thread starter Tractorbill
- Start date
- Views: 1543
Dave M7040
Elite Member
- Joined
- Dec 10, 2012
- Messages
- 2,757
- Location
- Williamstown Ontario Canada
- Tractor
- Kubota M7040 Nuffield 465
Most farm equipment use a standard spline fitting. However, there are many depending upon the size, etc.
What has gone wrong? Splines stripped or part(s) lost?
Can you post a couple of photos of the front of the engine where I assume there is a male spline the red circled part slips over.
Do you have a caliper with which you could measure the diameter of the male part in mm. It does not have to be an expensive one.
Here is a caliper for $15 from Northern Tool
Ironton 6in. Stainless Steel Digital Fractional Caliper | Calipers| Northern Tool + Equipment
Dave M7040
What has gone wrong? Splines stripped or part(s) lost?
Can you post a couple of photos of the front of the engine where I assume there is a male spline the red circled part slips over.
Do you have a caliper with which you could measure the diameter of the male part in mm. It does not have to be an expensive one.
Here is a caliper for $15 from Northern Tool
Ironton 6in. Stainless Steel Digital Fractional Caliper | Calipers| Northern Tool + Equipment
Dave M7040
OP
