I have a JD 4320. After bush hogging for about three hours the malfunction light started to blink. On the display it had an error code of either "cenph1" or "eenph1." I could not find this message/code any where in the owner's manual. Anyone know what this means? After I started the tractor back up the message went away. An hour or so later it came back on again.
Need Help with Error Message on a 4320
- Thread starter m_magpies
- Start date
- Views: 2073
Cidertom
Gold Member
- Joined
- Dec 14, 2005
- Messages
- 478
- Location
- Benton Co Oregon
- Tractor
- JD 4520, 2305 Aktive snow-trac ST4
Highest likley cause is a loose wiring connection. Something snagged a wire connector under the tractor and it is loose. I had this a couple of times on the 4wd engaged sensor.
B8FISH
Platinum Member
I'm not sure--but don't most (maybe all) of the error codes start err__? Any chance it was sending eeprom messages--only thing I could think of that was close.
