Matt need help
New member
- Joined
- Apr 23, 2023
- Messages
- 2
- Tractor
- None known
Disc Harrow Need help to ID this harrow disc
- Thread starter Matt need help
- Start date
- Views: 806
OP
Matt need help
New member
- Joined
- Apr 23, 2023
- Messages
- 2
- Tractor
- None known
I want to rebuild it, need good parts
ROUSTABOUT
Elite Member
- Joined
- Jan 30, 2008
- Messages
- 3,186
- Location
- Luther Willis Hill, AR
- Tractor
- Pettibone, Ford, Massey Ferguson, International, JD, David Bradley, home mades
I deal in them old implements. I have never had one they can't sell me parts for. Just measure the bearings, axle, disc, hubs, whatever you want. Make that call to a parts place. There's a 14' disc I'm pondering now. I bought a baler from him already.
ovrszd
Epic Contributor
- Joined
- May 27, 2006
- Messages
- 33,727
- Location
- Missouri
- Tractor
- Kubota M9540, Ford 3910FWD, Ford 555A, JD2210
I was able to buy gang bearings at O'Reilly's. Wheel bearings would be the same.
Discs, just need to take it apart and confirm center hole design/size, then determine diameter of disc you need.
Keep us posted on your progress!!!
MF243RedTop
Gold Member
ASC had all the bearings and assembly plates I needed to rebuild a 8 foot set of Long brand harrows..
As mentioned remove a section and take measurements of everything..
Axle length
Diameter
Bearing outer and inner
Assembly plate size and bolt pattern..
Spool lengths
End spacers..
I went with Brazilian made blades . Don't fall for the cheaper Indian made ones.. the sand will literally cut grooves in them.. ask my friend about that .
As mentioned remove a section and take measurements of everything..
Axle length
Diameter
Bearing outer and inner
Assembly plate size and bolt pattern..
Spool lengths
End spacers..
I went with Brazilian made blades . Don't fall for the cheaper Indian made ones.. the sand will literally cut grooves in them.. ask my friend about that .
