Need Advice on Lighting

   / Need Advice on Lighting #1  

jc7622

Silver Member
Joined
Apr 24, 2005
Messages
139
Location
Edmond, Oklahoma
Tractor
Montana 5740C
I will begin by saying that I am electrically challenged.

I do a some of my tractor work at night and want to upgrade to brighter overhead lights. How do I determine if a particular set of lights will not overload my circuit and blow fuses or melt wires? Do I need to stay below the amps of that particular fuse? Is there any rule of thumb for calculating the potential amps that will draw based on what the light mfgr's wattage?

JC
 
   / Need Advice on Lighting
  • Thread Starter
#2  
I will begin by saying that I am electrically challenged.

I do a some of my tractor work at night and want to upgrade to brighter overhead lights. How do I determine if a particular set of lights will not overload my circuit and blow fuses or melt wires? Do I need to stay below the amps of that particular fuse? Is there any rule of thumb for calculating the potential amps that will draw based on what the light mfgr's wattage?

JC
 
   / Need Advice on Lighting #3  
Watts divided by volts = amps.

You can always go the safe route and power the lights with a relay hooked directly to the battery and fused for the draw the lights will be pulling.

Ken
 
   / Need Advice on Lighting #4  
Watts divided by volts = amps.

You can always go the safe route and power the lights with a relay hooked directly to the battery and fused for the draw the lights will be pulling.

Ken
 
   / Need Advice on Lighting #5  
Hi JC,
I just upgraded my 5740C front lights to 55 Watt bulbs because the 35's kept breaking the filaments off from vibration. Don't know if anyone else is having this problem? Anyhow, they work just fine and make 1/3 more light. I left the same 10 amp fuse in the block also. I found the bulbs at TSC for $4.40 each. Hope this helps.

JimmyBean
 
   / Need Advice on Lighting #6  
Hi JC,
I just upgraded my 5740C front lights to 55 Watt bulbs because the 35's kept breaking the filaments off from vibration. Don't know if anyone else is having this problem? Anyhow, they work just fine and make 1/3 more light. I left the same 10 amp fuse in the block also. I found the bulbs at TSC for $4.40 each. Hope this helps.

JimmyBean
 

Tractor & Equipment Auctions

Unused 2025 CFG Industrial H15R Mini Excavator (A59228)
Unused 2025 CFG...
2019 CATERPILLAR 326FL EXCAVATOR (A60429)
2019 CATERPILLAR...
2007 MACK CTP713 TRI AXLE DUMP TRUCK (A59575)
2007 MACK CTP713...
UNUSED FUTURE FT-CL100C HYD CLAMP GRABBER (A52706)
UNUSED FUTURE...
Freightliner Fuel Truck (A56436)
Freightliner Fuel...
1996 International Water Truck with a Caterpillar Engine (A56438)
1996 International...
 
Top